Weak pressure of cold or hot water in the apartment - how to adjust: recommendations. The pressure of water fell: where to go?

The causes of poor water pressure and methods of eliminating the problem.

Content

The water supply pressure in the summer can decrease significantly. This is due to the irrigation season, which is especially true if you live near the private sector. In this article we will tell you why the house has a weak pressure of hot, cold water.

The pressure of hot water fell - what to do?

There are many reasons for the deterioration of the pressure of hot, cold water. First of all, it is necessary to ask the neighbors and figure out whether everyone has a bad pressure on the site.

The pressure of hot water fell, what to do:

If all the neighbors have encountered the problem, it makes sense to go down to the basement and see if the valve is not covered. It often happens that when replaced, or with some accompanying manipulations, the valve is not completely opened, respectively, the pressure of the water falls.
This is the easiest option, it is enough to completely open the valve and then the water pressure of all the inhabitants of the house will become much higher. If you asked your neighbors, and no one encounters a similar problem except you, then the case is directly in the apartment.
The most common option, due to which water pressure is reduced, is the hit of the scale. This happens if the riser is made of metal pipes. They rust, iron oxide can lag behind pieces from pipes and clog the system.
This usually happens directly in the mixer. In order to get rid of the problem, it is necessary to block the water in your apartment, unscrew the valve, which provides feed to hot cold water. In this case, it is necessary to unscrew the valve from which water does not flow well.

The pressure of water in the tap fell - how to improve the feed?

On the supply of each section there is a net that protects against mechanical impurities and collects them. It is enough to pull out the grid and rinse thoroughly. Usually, all the main garbage, scale, and mechanical impurities, which worsen the pressure of water, are collected on it.

The pressure of water in the tap fell:

If the sieve is clean enough, it is necessary to remove the valve and see what is under them. Remove valves, look inside. If you see that there is a scale, remove it. It often happens that there are large pieces that prevent normal pressure.
After they are removed and installed, the pressure is normalized. However, it often happens that when disassembling the mixer and removal of the scale, the situation does not normalize, and the water continues to flow with a very thin stream.
Perhaps the pipe hid somewhere on the supply to your apartment, or directly in it. Experienced locksmiths recommend using a special thin cable. It is found in a pipe with which the mixer is previously removed, and is cleaned. Thus, as a result of the use of a cable, all of the scale from the surface of the pipe is removed.

Weak pressure of water - reasons: what to do?

Quite often, it is clogged directly at the site of the insert, where your riser is connected to the water supply. If the pipes are metallic, most often scale is formed in places of welding. It is in these places that strong growths are found that prevent the normal pressure of water.

Weak pressure of water, reasons, what to do:

To get rid of them, you need to remove the ball screen, and try to clean the riser with a cable. Please note that if there is rust in this place, the growths of scale and scale growths are observed inside, then after cleaning it can start leaking, you risk flooding the neighbors.
In this case, the only true option is to replace this pipe section. It is best to replace plastic products. If the tap is ball, then there is a filter from below.
Thus, it will be possible to cope with the problem without blocking the supply of water to the whole house. It is enough to unscrew the filter and try to clean the riser of the supply of cold or hot water through it.

Poor pressure of cold water - what to do?

Often the filter can be clogged directly in the counter itself. The fact is that in this device, when water is supplied to it, there is a special mesh that prevents scale, rust and mechanical impurities in the measuring device.

Bad pressure of cold water, what to do:

The grid protect it from breakdowns. Therefore, one of the options to strengthen the pressure in the apartment is to unscrew the nut and clean the aerator. The same can be done with a net, which is located directly at the end of the mixer.
Small garbage can also be clogged in it. Often begins to flow the crane, at the junction of the husak with a pipe. This indicates that the grid was closed directly, which collects garbage in the mixer. If your neighbors are also familiar with a decrease in water supply, then perhaps a separate riser clogged.
Ask the neighbors who eat from another riser. It can be residents of the apartment that is opposite. If they have everything with pressure, the matter is in the riser itself and it is necessary to clean the filter, which is located in the place of the insert of the common pipe with your riser.

Low pressure of water in the apartment - how to improve?

If you are faced with this problem, you can use pipes of larger diameter. That is, you will have to replace old pipes with new ones, best from plastic. They do not form a scale, and there is also no rust inside.

Low pressure of water in the apartment, how to improve:

The higher the diameter of the pipe, the weaker it clogs. If the diameter of the pipes is very small, in the near future, the scale, or lime plaque may clog inside. You can also use the pump.
There are special small portable pumps that pump water. The cost of this equipment is not the smallest, but the issue with poor water pressure will be resolved. However, your neighbors can complain about you,because of They will lack water.
Typically, such a device increases water pressure by one and a half atmosphere. This is a completely safe value for home wiring of cold water.
If the pressure of water in the whole house falls, it makes sense to skip all the residents and purchase a portable pumping station. It consists of several pumps that work in autonomous mode.
The entire system is connected to automation, which regulates the need to turn on the pump at different times of the day. The higher the pressure and water pressure in the system, the less the pumps will turn on. With a decrease in water supply, especially if the private sector and the watering season are nearby, such a pumping station will work and turn on often. This will improve living conditions, and normalize the pressure of water.
Most difficulties arise with private houses that work from wells or wells, where there is no water supply. In this case, it is necessary to solve the problem with insufficient water.
Indeed, the pump cannot pump out water from the well, which is simply not there, it just can not have time to gather. In this case, the only true solution is the installation of a container for collecting liquid. Inside such containers, floats are installed, which regulate the water level. As soon as it falls below the required level, the pump will turn on and continue to pump water into the storage tank.

Why weak pressure of water from the boiler?

Residents of apartment buildings often face this, who do not have hot water supply. Accordingly, to obtain hot liquid, they use a boiler. There are several reasons why the pressure and pressure of hot water decreases, withwhat Cold water flows well enough.

Why weak pressure of water from the boiler:

The reverse pressure valve was clogged.
Insufficient adjustment of pressure gear in the boiler. Charges with a filter, a mesh on the mixer.
The water supply crane is not completely open to the boiler.

In general, all these problems can be solved independently, without the help of masters. To do this, check the net on the mixer. A nut on the tap is unscrewed, a metal filter is removed from there and washed in a solution of vaults. You can leave it for several hours in ammonia. This will allow you to clean the holes, and normalize the pressure.

It is also necessary to check whether the water supply crane is completely open to the heater. If the reverse pressure valve comes out, it is necessary to remove it and check it for the performance and the presence of garbage. The gearbox will have to be replaced if the problem is associated with a breakdown of the pressure regulator in the boiler. The master can cope with such work.

Weak water pressure, where to go?

Regarding the complaint, it all depends on which water flows poorly. If hot, you need to complain in the heat center, if it is cold, then inGorvodokanal. Please note that very often management companies do not want to spend money on appropriate repair. Therefore, endlessly redirects your application to another organization, which enters the same way.

It turns out that companies simply shift the guilt of each other, without doing anything. Accordingly, it is necessary to initially check the pipes in your apartment, chat with neighbors, and file a collective complaint. If only one tenant fits the complaint, then the probability of success is extremely low.

Weak water pressure where to contact:

The most initial stage is the appeal to the housing office. It is necessary to write a collective written statement that the house has weak pressure of water, which is not enough to satisfy the needs of the inhabitants. As a result of this complaint, the employees of the housing office are forced to come and check the pressure using special devices.
If it is below 2 atmospheres, then the appropriate measures should take. Please note that often the housing office refuses to accept an application. In this case, the ideal option is to send it by mail by registered letter with a report.
In this case, you can threaten by going to court. Typically, such statements are always considered in the first place. If nothing can be done, and several new houses were built, while the pump was left alone, respectively, the pressure will decrease.

You should not put up with the situation, you can reduce the cost of payment for cold water. Indeed, under the contract you pay for two atmospheres that will fully satisfy your needs. If the pressure is lower, you can achieve a reduction in payment.